Class A- Our cover will accommodate units up to 102” wide.
![]() |
Width – 102” Height/Side Wall – up to 120” Sizes Range from 18’- 48’ in length covers are in 2’ increments. |
Zippered Access
Units that range from 18’-26’ have two 108” zippers installed vertically along the side wall. Units that range from 28’-48’ have three 108” zippers installed vertically along the side wall. These zippers provide access to front or rear side doors on the unit.
Securing Cover:
The cover has elastic in the hem at the front and rear of the cover to snug against the unit. The cover also has an attached buckle and 12’ strap beside each zipper along the side wall. These straps go under the unit, side to side, to secure. Each cover has adjuster straps attached at the front of the unit that can be used to tighten the cover for a snug fit. The straps have a double pull buckle installed to allow the customer to pull each side to tighten. Also included in the package are 4 – 40’ tie-down straps. These straps go over and under the unit. Thread the loose end of the strap through the buckle and tighten.
*Note: On units with large fold-out mirrors, the mirrors should be folded in for best fit of cover.
Accessories Included in Package:
4 – 40’ tie-down straps
RV reinforcement kit
Matching Storage Bag
How to determine the correct size cover for a Class A:
EXAMPLE: Your Motor Home has a wall height of 12’6” listed in the spec sheet, and a length of 19’8”. We know that our cover accommodates air conditioners, ladders, ETC. On the smaller units the mid wheel height is estimated at 15”, on the larger units the mid wheel height is estimated at 18”. Air conditioners are estimated at 15”.
(Smaller units would be less than 20’, the larger units would be over 20’ – this depends on the unit type).
Take the Spec Sheet Height 150”
Minus the Wheel Height 15”
Minus the Air Conditioner 15” (Note sometimes A/C is not added into the height)
The height of the Unit becomes 120” (This should be indicated under the specs/pictures)
Based on that information you know our cover will work, the Class A has a wall height of 120”. The bottom of the cover will fall at mid-tire.
(For wider units, the bottom of the cover will fall toward top of tire, for narrower units, bottom of cover will fall nearer the bottom of tire).
PART # MHA1820P
LEAD TIME = 5 - 7 BUSINESS DAYS
*PLEASE NOTE: LEAD TIMES MAY VARY A BIT DURING HIGH VOLUME ORDERING IN SEASONAL MONTHS